General Operation - auna 10026466 Handbuch

Connection to a TV using the RCA - 3.5mm audio cable.
• Connect the 3.5mm (small) end of the cable
to the TV headphone 3.5mm audio output so-
cket.
• Connect the other RED & WHITE ends to the
TV inputs on the side of the Sound bar (9), ta-
king care to match the RED plug to the RED
socket and the WHITE plug to the WHITE so-
cket.
• NOTE: In some cases the Sound bar volume
output is effected by the volume level on the
TV. In this case adjust the TV volume to increa-
se the audio output from the sound bar.
Auxiliary connections
• The below diagram shows the connection to
an audio device such as an MP3 player, using
a 3.5mm audio cable.
• Connect one end of the 3.5mm audio cable
to the headphone output of your MP3 play-
er. Connect the other end to the AUX input
(3.5mm socket) on the back of the Sound bar
(8)
Mains connection
Connect the AC power adaptor between the DC IN socket on the back of the Sound bar and the power supply
outlet. Switch the power outlet ON.
Standby mode
• Press the STANDBY button (1 Unit & 21 Remote) to wake the unit from STANDBY mode.
• To enter STANDBY mode press either STANDBY buttons (1 Unit & 21 Remote).
• As part of the power saving mode the unit will enter STANDBY mode automatically after 20 minutes (approx)
of no audio output.
Switching inputs
Follow the below steps to switch inputs between: TV, Auxilliary, Coaxial, Bluetooth,Optical, USB or HDMI.
• Ensure the Sound bar is powered ON. If not press the STANDBY button (1) or remote (21).
• Press the SOURCE button (2, 20) repeatedly until you reach the required input mode.
• NOTE: When switching inputs there will be a 5 second pause after selecting BT while the unit scans for paired
devices.

General Operation

19