Panasonic ES-WS20 Bedienungsanleitung Seite 7

• If you are concerned about pain during epilation, then
please use with 1 (low speed) setting.
<Epilating legs or arms>
Upwards from the
bottom of the leg.
Inwards from the
outside of the arm.
Shaving
Before shaving, wipe away water or sweat on your skin.
1
1
Attach the shaver head [D].
2
2
Remove the bikini comb [C].
3
3
Check that the outer foil is not deformed or
damaged.
4
4
Slide the switch [E] to the 1 (low speed) or 2
(normal speed) position and carry out shaving.
• Press gently so that the whole blade is in close contact
with the skin and the surface of the blade does not move
up and down.
Downloaded from www.Manualslib.com manuals search engine
Cleaning
Always clean the frames and discs after use to keep them in a
hygienic state.
Switch off and unplug the appliance before cleaning.
1. Remove the frame by
holding the frame
release rib [B2] or
pushing the frame
release button [D7].
2. Clean the epilation head [B] and
the shaver head [D] with the
cleaning brush [G].
Replacing the outer foil
We recommend replacing the outer foil [D4] every year and
the inner blade every two years. Remove the outer foil of the
shaver head [D] only when replacing it.
1. While pushing the outer foil gently with the fingers, use a
fingernail to release the plastic panel (b) on the blade
from the hooks (a) on the inside of the frame.
2. The new outer foil should be slightly bent and pushed in
until it is hooked in the frame.


7