Dab; Listening To Dab Stations; To Select An Ensemble - JVC BoomBlaster RV-NB100B Bedienungsanleitung

DAB

Listening to DAB stations

To listen to DAB/DAB+
1
Press [TUNER] repeatedly to select
"DAB".
Remote control
2
Select the service.
When you change the source to DAB for the first
0
time after plugging in the power cord or after
inserting batteries, the System automatically
performs the scanning for the DAB bands to pick
out available ensembles. It will take a few
minutes depending on the location.
SCAN
When the scanning is complete, the System
0
starts playing the first service of the ensemble
found first.
When you move the System or adjust the
0
antenna position, perform the scanning. Press
and hold [SET] while DAB is selected as the
source.
Press [CANCEL] to stop scanning.
0
NOSIGNAL is displayed if scanning is
0
completed but no signal is found.

To select an ensemble

Press [UP] or [DOWN].
You can skip to the next/previous ensemble
0
found in the ensemble scanning.
It may take some time to change ensembles.
0
Main unit
(Press repeatedly)
To search for ensembles
1
Press and hold [UP] or [DOWN].
While you press and hold the button, the
channel changes through all of the
ensembles regardless of their signal status.
2
Release the button at the desired channel
of the ensemble.
To preset services
You can preset up to 30 DAB services manually.
1
Tune in to the service you want to preset.
2
Press [SET].
DAB P-01
3
Press the number button to select the
preset number you want to store.
You can also select by pressing [UP] or
0
[DOWN].
4
Press [SET] to store the station.
To cancel the presetting, press [CANCEL].
0
When you preset DAB services, you can only
0
preset primary services. If you select a
secondary service to store, its primary service is
stored instead.
To tune in to a preset service
You can select the preset station directly using the
number buttons.
23