RECARO C 6000 IVECO Stralis Einbauanleitung Seite 35

F
1
Direction of travel
1. Place the adapter (1) on the tunnel side and the adapter (2) on the door side on the vehicle floor. Take
note of the markings!
Important note:
Align the RECARO adapters in parallel so that they are 230 mm apart.
2. Tightly screw the adapters with the screws (3) and the nut (4) from the installation kit using the
stipulated torque. (size 5 hexagon socket and SW13 spanner).
Torque: M8 screws: 25 Nm ± 2 Nm
Warning!
Ensure that you neither exceed nor fall short of the torque listed above.
If the torque is insufficient, the screws will work loose whilst you are driving. The thread might be
damaged if the torque is too high. The risk of an accident and being injured whilst driving exists in
both cases.
The vehicle must be stopped immediately if a screw works loose and the screws must be replaced
by new screws and tightened up to the stipulated torque with the screw locking device.
RECARO Automotive Seating
3
2
4
1 Tunnel side adapter
2 Door side adapter
3 M8 x 30 installation kit screws
4 M8 installation kit nut
Page 12 of 23