Herunterladen Inhalt Inhalt Diese Seite drucken

Abkoppeln Des Batteriemoduls Oder Luftbefeuchters - Philips BiPAP A40 Kurzanleitung

Respironics
Vorschau ausblenden Andere Handbücher für BiPAP A40:
Inhaltsverzeichnis

Werbung

Batteriemodul
4
So schließen Sie das Batteriemodul
an das BiPAP A40 an und setzen die
ansteckbare Batterie ein:
1. Entfernen Sie die linke seitliche
Abdeckung a m Therapiegerät.
2. Richten Sie Batteriemodul und
Therapiegerät wie abgebildet
aufeinander aus.
3. Drücken Sie die Geräte
zusammen, bis sie hörbar
einrasten.
4. Setzen Sie die abnehmbare
Batterie in das Batteriemodul ein,
Humidi cation
und schließen Sie den Deckel.
Luftbefeuchtung
5
Humidi cation
Humidi cation
Humidi cation
With device turned o , remove and fill chamber with water.
1. (a) Lift humidifier door until it locks in place. Do not force
door higher than the locked position. (b) Grasp front of
chamber and slide toward you.
2. (a) Gently push tab located inside round opening on top
of chamber. (b) Separate top and bottom of chamber.
With device turned o , remove and fill chamber with water.
1. (a) Lift humidifier door until it locks in place. Do not force
door higher than the locked position. (b) Grasp front of
3. Fill bottom chamber with distilled water.
chamber and slide toward you.
2. (a) Gently push tab located inside round opening on top
of chamber. (b) Separate top and bottom of chamber.
4. Observe maximum fill lines located on sides of chamber.
3. Fill bottom chamber with distilled water.
5. Do not overfill.
Reassemble the chamber by p lacing the hinges on lid over the
two tabs on back of chamber. Close lid until it locks in place
with an audible click. Insert filled chamber into humidifier.
4. Observe maximum fill lines located on sides of chamber.
5. Do not overfill.
2
3
4
With device turned o , remove and fill chamber with water.
1. (a) Lift humidifier door until it locks in place. Do not force
door higher than the locked position. (b) Grasp front of
chamber and slide toward you.
With device turned o , remove and fill chamber with water.
1. (a) Lift humidifier door until it locks in place. Do not force
2. (a) Gently push tab located inside round opening on top
door higher than the locked position. (b) Grasp front of
of chamber. (b) Separate top and bottom of chamber.
chamber and slide toward you.
Abkoppeln des Batteriemoduls
oder Luftbefeuchters
2. (a) Gently push tab located inside round opening on top
3. Fill bottom chamber with distilled water.
of chamber. (b) Separate top and bottom of chamber.
3. Fill bottom chamber with distilled water.
4. Observe maximum fill lines located on sides of chamber.
4. Observe maximum fill lines located on sides of chamber.
5. Do not overfill.
Reassemble the chamber by p lacing the hinges on lid over the
two tabs on back of chamber. Close lid until it locks in place
with an audible click. Insert filled chamber into humidifier.
5. Do not overfill.
Reassemble the chamber by p lacing the hinges on lid over the
two tabs on back of chamber. Close lid until it locks in place
with an audible click. Insert filled chamber into humidifier.
Entriegelung
(Ansicht von
unten)

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis