In Case Of Problem - Parrot MKi9100 Bedienungsanleitung

Music
• Use the iPod, USB or Jack connectors to connect the
Parrot MKi9100 to your iPod / USB stick / audio player.
• You can also use the Parrot MKi9100 to listen to songs
stored on your mobile phone / PDA / smartphone. Your
mobile phone must support the Bluetooth® A2DP profile.
• To change the music source, press the jog wheel to
access the source menu and select it in the following
order :
- iPod (or iPhone) ;
- USB (MP3 player / USB flash drive) ;
- Audio Bluetooth
connected via Bluetooth) ;
- Line In (analogue audio player).
While playing a song, press the red button to get to
main menu. While navigating through the menus, press
the Play button to get to the Now Playing screen.
• There is no restriction in terms of capacity of USB stick.
Only MP3 (Mpeg 1 Layer3) or WMA formats are supported.
20
(audio player supporting A2DPprofile

In case of problem

Before you begin
• Make sure the "Good bye" message is displayed on the
Parrot MKi9100 screen when you turn the ignition off.
► Refer to the Checking the wiring section for more
information.
• Make sure you have the latest software update on your
Parrot MKi9100. To do so, select
settings > Information. Compare this number with the one
on our website, Downloads section.
Problems while using the phone function
• Make sure your phone is compatible with the Parrot
MKi9100. To do so, refer to the compatibility list of the
Parrot MKi9100 available on our website www.parrot.com,
in the Support & Downloads section.
• If your phone is compatible with the Parrot MKi9100 and if
you already have the latest software update:
1. Erase the memory of the Parrot MKi9100. To do
so, select Settings > Advanced settings > Factory
settings.
2. On your telephone, erase the Parrot system from the
list of Bluetooth peripherals (or reboot your iPhone).
Settings > Advanced