SATA AE5151 Bedienungsanleitung Seite 31

4.15 Adjustment for load test
- Fully put the four bracket arms aside to ensure that the track is barrier-free.
- Drive to the middle position of the lift, and keep the length ratio of the front part to the rear part of the vehicle (for those equipped with
front engine) around 2:3 when the connecting line of the posts is taken as a reference. When the tonnage of the vehicle exceeds 3.5T, the
vehicle shall be moved backward appropriately.
- Rotate the bracket arm tray to the support point of the chassis.
- Press the UP button to lift the bracket arms and ensure the 4 bracket arm locks are completely engaged.
- Continue to inch it up until a rubber tray has contact with the support point of the chassis, and then rotate other rubber trays
counterclockwise to bring them into contact with the support point.
- Press the UP button to lift the vehicle slowly until all tires are off the ground. Gently push the rear of the vehicle to check that the vehicle
is fixed firmly and the bracket arm locks are completely engaged.
- Press the UP button to continue lifting the vehicle and observe if the vehicle is stable during this process. Stop lifting the vehicle when
the sliding table rises to the third or fourth safety position, and press the LOCK button, after which the oil will return to the hydraulic
station and the sliding table will be locked. Observe if the vehicle is stable. (adjust the balance wire rope nut if there is an obvious height
difference between the left side and right side of the vehicle).
- Continue to lift the vehicle until it rises to the highest safety position, and then press the LOCK button, after which the oil will return to the
hydraulic station and the sliding table will be locked. Observe if the lift is stable without vibration.
- Press the DOWN button, after which the sliding table will rise a little, the electromagnet will open, the solenoid valve will be energized, the
oil will return to the hydraulic system, and then the sliding table will descend.
- Release the button when the sliding table is at any position in the middle, after which the safety lock will rebound automatically. Press the
LOCK button, after which the sliding table will be locked and stop descending.
- Press the DOWN button, after which the sliding table will rise a little, the electromagnet will open, the solenoid valve will be energized,
the oil will return to the hydraulic system, and then the sliding table will descend. Press the LOCK button when the sliding table is at any
position, after which the sliding table will be locked and stop descending. Repeat these operations for more than 3 times to verify safety
and reliability.
- While lifting the vehicle, check for abnormal sound and friction or interference between the wire rope and other components.
AE5151/AE5151-3
中文
EN DE RU KO PT JA ES
31