Foppapedretti FP Young Go! Evolution Gebrauchsanleitung Seite 18

GB
the belts are always at the height of your child's shoulders.(see paragraph ).
2- To tighten the harness : Pull gently on the harness adjuster to take up any slack in
the harness.WARNING : a loose harness is dangerous: it is recommended that there
is just enough room to insert two fingers between the shoulder straps and the
child's chest.
3- To loosen the harness : press on the tab of the central adjuster while at the same
time pull on both shoulder straps (Do not pull on the shoulder pads which are fixed
in length).
6 Adjusting the shoulder height
1- Fully recline the seat.
2- Loosen the harness in order to access to the metal yoke.
3- Remove one of the shoulder straps from the metal yoke.
4- Feed the shoulder strap that have undone through the shoulder slot in the back
of the shell and the cover.It is not necessary to feed the strap through the shoulder
pad.
5- Pull back the top part of the seat cover and white liner
- Release the metal keeper of the shouder restraint by feeding it back through the
slot,and through the liner and cover.
7- Re-assemble the harness by threading the keeper of the shoulder restraint back
through the desired slots in the cover,liner and seat.Make sure you thread the
keeper back into the slot below. Feed the shoulder strap back through the same
slot and re-attach onto the metal yoke. Then repeat the procedures for the shoulder
strap and restraint on the other side. Make sure there are no kinks or twists in the
straps. Replace cover on seat shell.
7 Reclining your child seat
8 User guide
It is important to refer the safety advices. Read these instructions carefully and
retain this user guide for future reference. An incorrect installation could be
dangerous.
9 Care of your product
The fabric cover can be removed from the seat.In case of light soiling,sponge
with a mild detergent and warm water, or hand-wash at 0°.Do not use chemical
cleaners,do not machine-wash,do not tumble-dry,do not iron.
NOTICE
1 - This is a "Universal" Child restraint.It is approved to Regulation N°44 series
of amendments,for general use in vehicles and it will fit most,but not all,car
seats.
2 - A correct fit is likely if the vehicle manufacturer has declared in the vehicle
handbook that the vehicle is capable of accepting a "Universal" child restraint
1