Resetting The Scale; Cleaning; Fault/Remedy - ADE PW 501 Bedienungsanleitung

RESETTING THE SCALE

Reset the scale to its default settings if unusual or obviously incorrect values are shown on
the display.
1. Remove the batteries and wait a moment.
2. Re-insert the batteries and replace the battery compartment cover.
After switching on the scale, you can start weighing as usual.

CLEANING

DANGER of electric shock (only when using the mains adaptor)
− Remove the mains adaptor from the connection socket.
NOTE on material damage
− Do not immerse the scale in water or other liquids.
− Do not under any circumstances use harsh, scouring or abrasive cleaning
agents or the like to clean the scale. Otherwise, the surface could be
scratched.
The scale should be cleaned immediately after use, especially after its contact with fat,
spices, vinegar, and other strongly flavoured and/or coloured foodstuffs.
− Wipe the scale as needed with a slightly damp soft cloth. Avoid contact with citric
acid.

FAULT/REMEDY

Fault
No function
The scale appears to be displaying
wrong weighing results.
"Err" is shown on the display.
"Lo" is shown on the display.
20
Possible Cause/Remedy
‚ Are the batteries empty or inserted the
wrong way around?
‚ Is the scale located on a firm, even surface?
‚ Is a device that can cause electromagnetic
disturbances located in the vicinity of the
scale?
‚ Proceed as described under "Resetting the
scale".
‚ The maximum capacity of the scale (5 kg) has
been exceeded.
‚ The batteries are empty, see "Changing the
battery".
PW501-190705-Rev001-UM-en