Transport Position - Husqvarna PG 400 Petrol Bedienungsanweisung

Transport position

To adjust the handlebar
The handlebar lock knobs are operated clockwise,
counterclockwise or put in idle position.
1. Loosen the lock knobs (A) and adjust the handlebar
(B) to idle position.
A
B
8
2. When the handlebar position is set, pull the handle
lock knobs up (A) and put them into idle position (B).
B
Handle heights
Hole position
Top
A
Center
Lower
To adjust the frame height
The angle of the frame can be changed to divide the
weight of the chassis. This is to decrease or increase
the grinding pressure against the surface.
1. Stop the engine. Refer to
page 12 .
2. Put 1 foot on the support frame. Use your hands to
push the angle joint handle on the central hinge. At
the same time fold the handle forward to transport
position.
A
A
B
Handle height, mm/in.
835/33
925/36
1000/39
To stop the product on
883 - 001 - 07.11.2019