Safety Instructions For Maintenance; Operation - Husqvarna PG 400 Petrol Bedienungsanweisung

• Examine the engine for leaks regularly. If there are
leaks in the fuel system, do not start the engine until
the leaks are repaired.
• Do not use your fingers to examine the engine for
leaks.
• Keep fuel in approved containers only.
• When the product and fuel is in storage, make sure
that fuel and fuel fumes cannot cause damage.
• Drain the fuel in an approved container outdoors and
away from sparks and flames.

Safety instructions for maintenance

• Always put the throttle control to stop position (A),
before maintenance of the product, Refer to
control on page 11 .
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
WARNING: Be careful when you adjust the
handlebar between the operation position,
the servicing position and the transport
position. The handle is heavy and must be
held tightly. Look around you before you
adjust the handle position, to prevent
damage or injury.
Product positions
Engine start position
883 - 001 - 07.11.2019
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
• Stop the product when you replace the diamond
tools.
• Do the inspection and/or maintenance with the
engine stopped.
• Always let the engine become cool before you do
maintenance of the product.
• Make sure to do the do maintenance of the product
on stable horizontal ground.
• Do the maintenance to make sure that the product
operates correctly. Refer to
Throttle
13

Operation

Operation position
Servicing position
Maintenance on page
CAUTION: Only put the product in the
servicing position on a horizontal surface.
7