Throttle Control - Husqvarna PG 400 Petrol Bedienungsanweisung

5. Put the product into operation position.
To connect a dust extractor
When dry grinding, use a Husqvarna dust extractor
Technical data on page 17 .
system. Refer to
Recommended dust extractors are Husqvarna T 4000
Petrol or S 36.
1. Connect the dust extractor to the product.
2. Make sure that the filters in the dust extractor are
clean and not damaged. Monitor the dust during the
operation.

Throttle control

The throttle control has 3 available positions:
• Stop position (A).
• Operation mode position (B).
• Start position/choke position (C).
883 - 001 - 07.11.2019
A
WARNING: Always put the throttle control in
stop position (A) when you stop the product
to prevent accidental start.
To control the operation direction
During operation, the product can pull to the sides. The
direction of the pull is related to the direction of rotation
of the grinding head and how the product is operated.
• Always keep the 2 wheels on the ground during
operation of the product.
• Apply the side forces on the handle to steer the
product.
• Always hold the handle tightly with 2 hands to stay
stable and make sure that the product does not
move laterally.
To fill fuel
If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
quality unleaded gasoline or leaded gasoline with octane
number not less than 90.
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
2 different fuel tank caps
The product is supplied with 2 different fuel tank caps.
• The fuel tank cap for operation is attached to the fuel
tank. This fuel tank cap has venting and lets the
engine operate.
B
C
11