Vermeiren D200 Gebrauchsanweisung Seite 16

Whenever feasable, use the seat of the vehicle and store the wheelchair in the cargo area.
Steps to secure the wheelchair in a motor vehicle:
1. Check that the vehicle is equipped with a suitable wheelchair tie down and occupant-
2. Check that the components of the wheelchair tie down and occupant restraint system
3. If equipped with an adjustable seat and/or back tilt, make sure that the wheelchair
4. Remove all mounted accessories such as trays and respiratory equipment, and
5. Position the wheelchair facing forward in the travelling direction, centrally between
6. Make sure that the indicated zones around the wheelchair user are clear from rigid
7. Mount the front securement straps according to the instructions of the strap-system
8. Roll back the wheelchair until the front straps are tight.
9. Apply the wheelchair brake.
10. Mount the back securement straps according to the instructions of the strap-system
11. This place is marked on the wheelchair with a symbol. (figure 4)
Downloaded from www.Manualslib.com
restraint system, conform ISO 10542.
are not frayed, contaminated, damaged or broken.
user is sitting as upright as possible. If the user's condition prevents this, a risk
assessment should be done to evaluate the user's safety during transit.
secure them in a safe place.
the tie-down rails mounted in the floor of the vehicle.
vehicle parts.
manufacturer at the indicated place. (figure 3)
This place is marked on the wheelchair with a symbol. (figure 4)
manufacturer at the indicated place. (figure 3)
Figure 3
manuals search engine
Handgrips in
lowest position
Page 14
D200
2014-08