Edited Recording On Sides A And B Of A Tape - Denon RCD-M33 Bedienungsanleitung

ENGLISH

Edited Recording on Sides A and B of a Tape

This function allows edited recording according to the length of the tape. (This operation is only
possible from the remote control unit.)
Edited recording is a system function of the RCD-M33 and DRR-M33. This function can only be
used in combination with the DRR-M33.
• Use this function to efficiently edit the tracks on a CD according to the length (time) of the tape
onto which you want to record.
NOTES:
• Load a blank cassette tape onto which you want to record in the cassette deck with side A
on the top before starting the editing procedure. The tape is automatically wound to the
beginning before recording starts.
• The editing mode is canceled when the CD receiver's STOP button is pressed.
• Note that even if the tape is slightly longer than the disc's total playing time, it may not be
possible to record all the tracks on sides A and B because of the combination of tracks to be
recorded on the different sides of the tape.
• When recording on an already recorded tape, if the tape is longer than the new recording,
the previous recording will remain at the end of side B, so erase the tape before starting.
• During edited recording, only the STOP button, power operation switch, and TIME/DISPLAY
button for the CD player section and the stop button and power operation switch for the
cassette deck will function.
• Set the reverse mode on the cassette deck (DRR-M33) to
recording.
• Edited recording does not function when you play a disc with more than 26 tracks.
• This function is not available for MP3/WMA discs.
(1) Recording the tracks in the same order as on the disc................................................
1 2, 3
Press the FUNCTION button to
1
set the CD mode.
Press the 5 (open/close) button to open the
2 disc tray.
• Load the disc in the disc tray.
5
Press the (open/close) button to close the
3 disc tray.
• The display appears after several seconds.
24
or during edited
Automatic Edited Recording
5
1
4
2
5
Main unit Remote control unit
Main unit
Main unit
Press the EDIT button on the remote control
unit to set the length of the tape. (The length
is the total for sides A and B.)
• For a 60- minute (C- 60) tape, press the
EDIT button 2 times.
• The display changes as shown below each time the
EDIT button is pressed.
(If the tape length has already been set once, the
display changes starting from that length.)
C-46 C-60 C-90 C---
4
(nothing displayed)
Inputting other tape sizes:
• To input other tape sizes, use the number and +10
buttons when "C ---" is displayed.
After this, the remaining times for sides A and B are
displayed alternately for 5 seconds.
1 3
Press the / (play/pause)
button.
• The tape is automatically
5
wound to the beginning on
Main unit
the cassette deck, then
recording starts.
• To set a time other than 46, 60 or 90, input the time when "C —" is displayed. The time can
be set to up to 99 minutes input in the same way as when inputting track numbers for the CD
direct search operation.
Example: For a 60-minute tape
Remote control unit
Side A display - Tracks 1 to 9
will be recorded on side A.
2 minutes 40 seconds remaining
on side A
Side B display - Tracks 10 to 16
will be recorded on side B.
1 minute, 20 seconds remaining
on side B
Track no. Elapsed time
Remote control unit