Listening To Preset Stations - Denon RCD-M33 Bedienungsanleitung

ENGLISH
Presetting or naming radio stations
(This operation is only possible from the remote control unit.)
You can preset up to 40 FM/AM stations.
You can name the preset stations (up to 8 characters each).
1 Tune in the desired preset station.
Press the EDIT button on the remote
2 control unit.
• You can now begin character input.
9 8
Press the / button until the
desired character appears on the display.
Press the ENTER/MEMO button on the
remote control unit to store the input
character.
• Press the 7 button
3 ENTER/MEMO button to store the input
character. The cursor will move to the
next character space. Repeat step 3 until
all the characters have been stored.
• You can move the cursor backward by
6
pressing the button to make
corrections.
Press the EDIT button to confirm the
4
names of the preset stations.
.
9 8
Press the / button on the
5
remote control unit to tune in the
desired preset number.
Press the ENTER/MEMO button to confirm
6
the preset station number.
• To change a preset station name, press the CH+(
you want to change, then press EDIT and use the same procedure as in step 3 above to
change.
• To preset only the frequency of the radio station, start over from step 1. Then press the
ENTER/MEMO button and proceed to steps 5 through 6. The display shows the preset number,
band and frequency.
14
Flashes
or the
ENTER/MEMO
Next Flashes
9 )/ CH–( 8 ) to display the preset station

Listening to Preset Stations

If the following operation is performed when the system power is off, the power automatically
turns on and the radio is played. (Auto on function)
Example: Listening to the station preset at number 3
Press the FUNCTION or
1 TUNER button to select TUNER
mode.
Main unit
9 8
Use the " " and " " buttons to select preset
number "3" or press the "3" button on the numeric
keypad to display preset number "P03".
9 8
• The " " and " " buttons on the main unit can
be selected when the preset mode has been set.
2
(Press the /BAND and + buttons at the same time to
2
change the Preset mode.)
Main unit
Remote control unit
Using the RDS functions
(This operation is only possible from the remote control unit.)
Receiving RDS broadcasts (FM only)
Press the BAND button and set
1
the FM AUTO.
Main unit
2 Press the RDS button.
7
Press the TU+( ) or
3
6
TU–( ) button. (auto tuning)
4 The station is tuned in.
NOTE: If no RDS station is found, " NO PROGRAM " is displayed.
Remote control unit
Remote control unit
Remote control unit
Reception frequency