Specifications - Makita BTW450 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Switch trigger
3-1. Lamp
3-2. Lamp switch

SPECIFICATIONS

Capacities
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for fastening bolts and nuts.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN60745:
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Downloaded from www.Manualslib.com
Explanation of general view
4-1. Socket
4-2. Anvil
5-1. Socket
5-2. O-ring
5-3. Pin
6-1. Groove
Model
Standard bolt
High tensile bolt
Square drive
-1
No load speed (min )
Impacts per minute
Max. fastening torque
Overall length
Net weight
Rated voltage
) : 94 dB(A)
pA
) : 105 dB(A)
WA
Wear ear protection
total value (tri-axial vector
2
) : 19 m/s
h
2
manuals search engine
ENE036-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENG102-3
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
ENG205-2
manufacturer declare that the following Makita
machine(s):
sum)
Designation of Machine:
Cordless Impact Wrench
Model No./ Type: BTW450
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
ENG901-1
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
6-2. Screw
6-3. Hook
8-1. Limit mark
9-1. Brush holder cap
9-2. Screwdriver
BTW450
M12 - M22
M12 - M16
12.7 mm
1,600
2,200
440 N.m
266 mm
3.4 kg
D.C.18 V
Corporation as the responsible
ENH101-13