Bimar VSB10 Bedienungsanleitung Seite 10

1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Some fans may be supplied with a lamp. The lamp placed under the motor can be
Downloaded from www.Manualslib.com
Fax +32 030 9904733
Attach the mounting plate to the ceiling: drill the holes,
taking care not to damage any piping inside the wall (first
check if there are water or gas pipes etc. .. or electrical wires
embedded in the wall); use expansion dowels and screws
with washers to attach the plate. Make sure it is firmly
attached, then apply a weight to the plate 4 times higher
than that of the fan and check that the plate remains
perfectly fixed to the base.
Insert the support rod through the top cap and insert the
electrical cables through the hollow shaft. The wires are
inserted from bottom to top.
Insert the lower end of the rod into the motor support pin,
so that the holes are coaxial and insert locking pin.
Place the washer on the pin and secure the pin using the
cotter pin which must be fully inserted and then bent so as
to prevent both the pin and cotter pin from slipping off.
Fix the motor support further to the rod by tightening the
safety screw
Temporarily hang the fan on the hook on the support plate
as explained in the "Electrical Connection" section and then proceed as follows.
Remove the fan from the hook on the support plate
the electrical connections. Check that the wires are free and housed in the correct way and
position the top cap near the support plate. Tighten the screw properly.
Attach the blade supports to the blades using screws with washers and nuts, and tighten
appropriately. For some models, the blades are not reversible, so fix the support to the right
side of the blade. For some models nuts are not needed and are therefore not provided.
Mount the blades to the motor, placing them in the correct way (pay attention to the side of
the blade), and screw on the blade supports with the screws and washers supplied. Check
that all screws are tightened in the correct way, both for safety purposes, but also to prevent
the fan from swinging excessively during operation.
assembled and connected in advance, or it will be supplied in a kit to connect and assemble.
In this case, simply screw the bulb (not included) corresponding to the specific details given
on the nameplate and / or on the data plate near the socket. To type VSL10 e VSB10
(4xMax60W, lamp holder E14).
manuals search engine
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
Make the electrical connections
hold it up so as not to tear / damage
10 40
/
Assembly page 10/16