Changing The Temperature; Power Failure - Gram FS Serie Bedienungsanweisung

GB
Within a few moments after the keys have
been held down, you will be able to read
the temperature setting on the display. The
setting will be displayed for approx. 3
seconds. Keeping the keys pressed down
will enable you to change the setting (see
below).
Changing the
temperature
Press "TEMP." and hold it down. In a
moment or two you will see the actual set-
ting on the display and for appox. 3
seconds the small lamps will light up, one
after the other, along the
scale. When the end of the scale is
reached all lamps will go out for an instant
before starting to light up again. Release
the "TEMP." key when the lamp opposite
the temperature you require lights up. The
freezer will now run at this setting. .
Freezing down
When freezing down, it is necessary to
choose whether freezing down is to run for
one or for two days (24 or 48 hours). Press
"FREEZE" and hold it down. In a moment
or two you will see the actual setting. At the
same time, in sequence, one, two or no
lamps on the temperature scale will light
up. The number of green lamps that light
up indicates the number of freezing-down
days. Release the key when the required
number of days is indicated. The freezer
will now run at this setting. The small yel-
low indicator lamp will light up for as long
as the freezing-down process is running.
Freezing down is switched off automatically
when the selected time has elapsed. The
freezer then continues to run on the normal
setting. An economy function ensures that
during freezing down the temperature
never falls below -28°C.
Downloaded from www.Manualslib.com manuals search engine
The freezing-down process can be stop-
ped manually by pressing the "FREEZE"
key as described above and then releasing
it as soon as no lamps light up.
Note!
Pack your frozen items in airtight and
waterproof containers to prevent drying
out. Portions should be as flat as possible
to ensure rapid freezing through.
To obtain effective freezing down of many
items at the same time, start the freezing
down process 24 hours before items are
placed in the cabinet. If a smaller quantity
of items is to be frozen the period can be
made shorter. If only single packs are to be
frozen, no prior freezing period is necessa-
ry.

Power failure

After power failure the cabinet starts auto-
matically. As soon as power is restored,
the cabinet runs and the alarm is activated
(see section on alarm).
Alarm
The alarm activates if the power fails, or if
the cabinet temperature remains 6°C high-
er than the setting for more than two hours.
The alarm will continue even after the tem-
perature has returned to normal, just to tell
you that something went wrong.
The alarm is automatically switched off
when current is restored following power
failure unless the temperature in the cabi-
net has risen more that 2°C above the fact-
ory setting.
Alarm on starting
Your new GRAM model has not been con-
nected to a power supply since it was test-
ed at the factory, therefore the electronic
control "thinks" there has been a power
failure when you connect up the freezer in
your kitchen, and thus activates the alarm.
41