Cordivari Claudia Bedienungsanleitung Seite 19

English
1 7
2 6
3 4 5
Active function
Disactive function
Note: The device could fail in detecting an opened window e.g. if the
thermostat is located on an isolated area of the room and far from air
currents or if the thermostat is placed close to an external heating
source, or if the temperature variation in the room is too slow.
Note 1: When the symbol " " is on, the heating element is
active.
Note 2: In case of loss of power supply, the settings of the "Chro-
no" mode (current day of the week, current time, daily program
for the week) remain stored in memory for a few minutes.
Only for TOP versions:
Remote Control (OPTIONAL)
The electronic control is provided of an IR receiver inside, for this
reason it is possible to drive the heater through a remote control (op-
tional).
All the above described 'on-board' functions are also available on the
Remote Control.
This icon [ ] indicates that it is being received signal from the
remote control.
*The version with Fil-Pilot is available for specific countries.
- 19 -
Cod. 1910000000048 - nv03