Cordivari Claudia Bedienungsanleitung Seite 18

English
Programming the "Chrono" mode
a) Setting the current day of the week and time
- Enter into "Stand-by" mode and press the [-] button at least 3 se-
conds.
- On the upper part of the display the message "Set" will be displayed.
- To set the day and time press the [+] button until the bottom part of the
display the message "TED" is displayed (see picture below).
- Press the [Prog] button to enter the editing mode.
- The blinking arrow indicates the currently selected day: Pressing the
[+]/[-]
buttons the desired day can then be set.
- Press again the [Prog] button to confirm the selected day. After that, the
procedure for entering the time starts and the display shows the currently
selected time. "Hours": Use the [+] and [-] buttons to set the correct hour
and confirm the selected value pressing the button.
Minutes: Same procedure as for the hours. Confirm the selected value by
1
pressing the [Prog] button.
2
- At the end of the procedure, the thermostat returns into "Stand-by"
mode.
b) Setting the program for the "Chrono" mode
1
2
- Enter into "Stand-by" mode and press the button [-] at least 3 seconds.
- On the upper part of the display the message "Set" will be displayed
- To set the day and time press the button [+] until the bottom part of the
display the message "Prog" is displayed (see picture below).
- Press the [Prog] button to enter the editing mode
- Now a time sequence can be defined for each day of the week.
The procedure starts with day 1, and the desired sequence can be
configured with the [+] and [-] buttons:
For each hour of the day, it is then possible to assign either the
"Comfort" temperature (full bar indication displayed) by pressing the [+]
button or the "Night" temperature (empty bar) by pressing the [-] button
(see picture below). Press [Prog] to confirm the entered configuration for
day 1, and repeat the same procedure for the remaining 6 days of the
week.
1
2
*The version with Fil-Pilot is available for specific countries.
7
6
3 5
4
7
6
3 5
4
7
6
3 4 5
1
2 6
3 5
4
Key lock
It is possible to lock the buttons of the device to avoid inadvertent
modifications of the settings.
Press together the buttons [PROG] for 3 seconds to lock all the but-
tons except the [On/Stand-by] button. The key-lock icon is activated
on the display.
To unlock the buttons press again together the [PROG] buttons for 3
seconds.
The key-lock icon disappears on the display:
1
2 6
3 5
4
"Open Window Detection" function
The "Open Window Detection" function enables detecting of an open
window by sensing a sudden decrease of the temperature in the
room. In such a case, the device deactivates the heating element for
a maximum of 30 minutes or until an increase of the room temperature
reveals that the window has been closed.
To activate this function:
- Enter into "Stand-by" mode.
- Press the [+] button for 3 seconds.
- Press the [+] button to activate / deactivate the function
- Press the [Prog] button to commit and return into "Stand-by" mode.
When this function is enabled, the "Open Window" icon on the display
is lit.
When the device detects that the window is potentially opened, the
"Open Window" icon starts blinking
When the function is disabled the "Open Window" icon is not shown
on the display:
- 18 -
1 7
2 6
3 5
4
7
7
1 7
2 6
3 4 5
Cod. 1910000000048 - nv03
1
2