B) Lc Display; Display Symbols - VOLTCRAFT SMD-2125 Bedienungsanleitung

b) LC display

A Lower tolerance limit
B Current measured value
C Minimum value
D Number of measurements
E Average value
F Maximum value
c) Display symbols
Set acoustic messages
Calibration mode display
Set warning LED
Perform continuous measurement
Adjust backlight
D
C
B
A
E F
G Low battery level indicator
H Switch display rotation off
I Type of substrate (Fe=ferrous, NFe=non-
ferrous)
J Layer thickness unit of measurement
K Calibration mode (set to two-point)
L Upper tolerance limit
Display upper limit value
Reset to factory settings
Unit setting
Display lower limit value
Delete saved data
G
H
I
J
K
L
35