MADRIX STELLA Handbuch Seite 12

How To Install On DIN-Rails
Unmounting (Pictured Right)
Step 1) Pull the unlocking clip.
Step 2) Lift the lower part of the device from the
rail in an angle.
Step 3) Lift the device from the rail.
Using The MADRIX
You can mainly use 3 operating modes together with the MADRIX
 DMX-OUT And/Or DMX-IN Via Art-Net
 DMX-OUT And/Or DMX-IN Via Streaming ACN
 DMX-OUT And/Or DMX-IN Via USB
In MADRIX 5, make sure to activate the correct drivers first:
®
– For USB, go to 'Preferences' > 'Options...' > 'Devices USB',
– For sACN, go to 'Preferences' > 'Options...' > 'Devices Network',
– For Art-Net, go to 'Preferences' > 'Device Manager...' > 'Art-Net'.
Configure and activate your devices in order to send or receive data:
– Go to 'Preferences' > 'Device Manager...' > 'DMX Devices',
– Go to 'Preferences' > 'Device Manager...' > 'DMX Input'.
For more information, please read the MADRIX
11
EN
Mounting (Pictured Left)
Step 1) Hook the device in an angle onto the upper
edge of the rail.
Step 2) Pull the unlocking clip.
Step 3) Press the lower part of the device against
the rail and let the clip snap into position.
5 Software
®
5 user manual.
®
5 Software:
®