Safety Notes; Designated Use - Litecraft PowerBar AT10.sx Bedienungsanleitung

Safety Notes

• Each person which is responsible for the installation, the use
or service of this unit must be:
• qualified
• has to follow the instructions in this manual.
WARNING!
Be careful when using the device. You risk an electrical shock
from high voltage, if you touch the wires!
• The device has left our company in manufacturer proofed
state. To maintain this status and to ensure a permanent
safe operation, it is absolutely necessary to follow the safety
instructions and warnings in this manual.
IMPORTANT!
Errors, caused by not following these instructions are not
covered by the warranty. The manufacturer will not accept
liability for any resulting defects or problems.
• Keep the unit away from radiators or other heat sources!
• If the unit has been exposed to tremendous temperature
changes (e.g. after transportation), do not turn it on imme­
diately. The resulting condensation could damage the unit.
Don`t switch unit on until the device reaches room tempera­
ture.
• This device belongs to protection class I. Therefore, it is im­
perative that the green/yellow wire is connected to the earth
contact of the plug. The electrical connection must be made
by a qualified person.
• Make sure that the cable has never been squeezed or dam­
aged by sharp objects. Check the device and the cables regu­
larly.
• If the cable is damaged, it must be replaced immediately by
the manufacturer, its service agent or a qualified person in
order to avoid danger.
• Lenses, glasses or UV filters must be replaced if they are
visually damaged, or their effectiveness is impaired, e.g. by
broken glass or by deep scratches.
• Ensure that wires never come in contact with other wires!
Handle the power cord and all connections with caution!
• Make sure that the line voltage is not higher than the voltage
specified in this manual.
• Disconnect the unit from the AC mains when it is not in use or
when cleaning it. Disconnect the connection only by pulling
the cable plug.
• Using the fixture for the first time, can result in light smoke
and odors. This is a normal process and does not constitute a
defect.
14
RISK OF BURNS! Do not touch the unit during operation! The
housing may reach high temperatures.
RISK TO HEALTH! Never look directly into the light source.
Especially epileptics risk an epileptic shock! Disconnect the unit
from the AC mains when not in use or when cleaning it.
• Defects caused by modifications of the device by unqualified
handling or an unqualified person are not covered by the
warranty.
• Keep the product away from children and unskilled people.
• There are no wear parts in the device. Maintenance and ser­
vice must be performed only by an authorized service partner.

Designated Use

This product is a spotlight, which is designed only for professi­
onal use on stages, discotheques, theatres, etc. This product is
approved for mains connection up to 240 VAC and designed for
indoor use only.
• Please avoid any kind of shocks and outer actions during its
installation or transportation.
• Take care of too high ambient temperature, humidity and
dust when choosing the installation location. Assure that all
cables are fixed. Incorrect operation may lead to danger.
...m
shows the minimum distance to illuminated
• Image
objects. Minimal distance between fixture and illuminated
surface is 0,3 meters.
• Assure that the area below the mounting position of the
fixture is roped in while mounting, dismantling and service.
• The spotlight itself and its accessories like color frame and
barndoors have to be safed with a suitable safety chain.
• Assure that the maximum ambient temperature is never
exceeded.
• Do not put the fixture in operation before you are familiar
with its functions. Keep the product away from children and
unskilled people.