Outside Air Connection - Dik Geurts Ivar 10 H2O Installationsvorschrift

IN S TA LLA TION M A N U A L

9.5.1.1 Outside air connection

Outside air connections are available for these appliances as accessories. Assembly always takes place at the
bottom of the appliance. Connection is possible via both the rear and bottom side.
When installing an RS appliance, the outside air connection is already pre-mounted on delivery. If so, observe the
Caution!
steps as described under the heading 'Outside air connection pre-mounted'.
Outside air connection not pre-mounted:
When connecting the outside air connection, proceed as follows (see appendix 2, fig. 7, 8.1 and 8.2):
Ø
Loosen the 8 bolts that are pre-mounted on the outside air connection.
Ø
Bring the outside air connection against the plate on the bottom of the appliance.
Ø
Then re-tighten the 8 bolts.
Ø
Mount the air slide by means of two socket-head screws.
Now decide whether you will be using a rear or bottom connection.
In case of a rear connection (see appendix 2, fig. 8.1):
Ø
Fasten the tray for the benefit of the rear connection with 4 bolts.
Ø
Connect the flexible hose to the round 'pipe opening' of the above-mentioned tray. The flexible hose can only be
supplied from the rear.
The round pipe opening for the benefit of the lower connection is not needed during installation and should be
Caution!
disposed of responsibly.
In case of a bottom connection (see appendix 2, fig. 8.2):
Ø
Mount the supplied round pipe opening using 4 bolts.
Ø
Connect the flexible hose (Ø 80 mm) to this pipe opening.
The tray with round pipe opening for the benefit of the rear connection is not needed during installation and
Caution!
should be disposed of responsibly.
Outside air connection pre-mounted:
Ø
Connect the flexible hose (Ø 80 mm) to the round 'pipe opening' of the outside air connection.
In the case of an RS appliance, you are dealing with a fully closed system. Always ensure an air-tight connection of
!caution
the flexible hose to the round 'pipe opening' by using a heat resistant sealant.
For disassembling the outside air connection, please observe the above-mentioned steps in reverse order.
39 NL