LaserLiner Cubus Bedienungsanleitung Seite 15

The ADS is not active following switch-on. Once the device has
been set up, press the tilt button to activate the ADS, enabling you to protect
the laser from changes in position caused by the device being disturbed by
external factors. The tilt LED flashes to indicate that the ADS function is
active; see the diagram below.
The ADS does not activate the monitoring function until 30 seconds
!
after the laser levelling procedure has been completed (set-up phase).
The tilt LED flashes every second during the set-up phase, rapid
flashing, when ADS is active.
ADS function
ON
Adjustment phase
Sensor Automatic
Transport LOCK: The device is protected by a special motor
brake during transport.
IP 66
The device characterised by specific protection against
dustand rain.
Space grids: These show the laser planes and functions.
auto: Automatic alignment / man: Manual alignment
auto
Horizontal
levelling
Rotation
begins
ADS activation:
press the tilt
button; the tilt
LED flashes every
second.
auto man
Vertical Inclined plane
levelling
Cubus / Cubus G
ADS active after
30 seconds, rapid
flashing of the
tilt LED.
90° angle
External
influence
The
laser
remains stationary as
a precaution, the laser
flashes and the tilt
LED is lit continuously.
90° reference
function
15
EN