Operation
Using the cable winder
The cable winder can be used to adapt the length of the earphone 1
cable to your needs and for storing the earphones when they are not
being used.
Remove silicone cap of cable winder 3 and lead the cable
■
through the side recesses and the middle bar of the lower shell.
■
Fold over the silicone cap towards the outside and place it on
the middle bar of the lower shell again.
■
Wind one end of the cable around the middle bar until the
required cable length has been reached, and then lead it back
through the recess in the lower shell.
■
Fold the silicone cap back inwards again. Ensure that the recesses
in the silicone cap and the lower shell are in alignment with
each other.
SKAO 120 A1
GB
49