Function Settings; Water Hardness - Melitta CAFFEO SOLO Bedienungsanleitung

Use the test strip provided to determine the water hardness in your area. Please
comply with the instructions on the test strip packaging. Water hardness is set to 4
in the factory. If you have inserted the Melitta
is set automatically (see page 50).
Prerequisite: The appliance must be ready for operation (see „Switching on
and off" on page 49).
To maintain appliance quality, please adjust the water hardness as follows:
•
•
•
Water hardness range
4:
54 54
Downloaded from www.Manualslib.com
8

Function settings

8.1

Water hardness

Simultaneously press both the button for one-cup dispensing
the button for two-cup dispensing
→ The standby symbol
Press the button for one-cup dispensing
for adjusting the water hardness.
→ The symbol for the water filter
Press the button for coffee strength
the four possible degrees of water hardness.
→ Your water hardness selection according to the table is shown with the bean
symbols on the display.
1:
2:
3:
flashing
manuals search engine
Claris water filter, water hardness 1
® ®
for more than 2 seconds.
is flashing rapidly.
once to call up the menu
is illuminated.
several times to select among
Properties
soft 0 - 7.2 °dH
medium 7.2 - 14 °dH
hard 14 - 21.2 °dH
very hard
> 21.2 °dH
(factory setting)
and
°dH °f
0 - 13 °f
13 - 25 °f
25 - 38 °f
> 38 °f