Function Settings; Adjusting The Water Hardness - Melitta LATTEA Bedienungsanleitung

0 Function settings

Adjusting the water hardness

use the included test strip to determine the water hardness in your area. comply with
the instructions on the test strip package. The appliance is factory-adjusted to water
hardness 4. If you have inserted the Melitta claris
automatically (see p. 53)
Prerequisite: The appliance is ready for operation, the standby symbol
is illuminated.
To maintain appliance quality adjust the water hardness as follows:
• simultaneously press the button for single-cup dispensing
button for two-cup dispensing
→
the standby symbol
• Press the button for single-cup dispensing
sting the water hardness.
→
The symbol for the water filter
•
Press the button for brewing strength
the four possible degrees of water hardness.
→ Your selection of water hardness in accordance with the table is indicated via
the bean symbols
Water hardness range
:
:
:
:
0
Heft_Lattea_EU.indd 60
is flashing rapidly.
in the display.
Properties
soft
medium
hard
very hard
flashing
(factory setting)
water filter, water hardness 1 is set
®
for more than 2 seconds.
to call the menu for adju-
is illuminated.
several times to select between
°dH
0 - 7.2 °dh
7,2 - 14 °dh
14 - 21.2 °dh
> 21.2 °dh
and the
°f
0 - 13 °f
13 - 25 °f
25 - 38 °f
> 38 °f
09.07.2009 15:29:01