Staples
Handle the staples and their box carefully. If the
•
staples have been handled roughly, they may be
bent out of shape, causing poor staple feed or
jamming.
Avoid storing the staples in a very humid or hot
•
place or place exposed to direct sunlight.
Do not attempt to use staples that appear to be
•
damaged, bent, rusty or corroded.
Loading staples
Fig.6
Press the plate spring on the rear of the sub-magazine
and slide the sub-magazine backward.
Load staples into the main magazine with staple ends
facing up as illustrated. Slide the sub-magazine forward.
Fig.7
To secure the sub-magazine in place, push the
sub-magazine while pressing the plate spring on the rear
of the sub-magazine.
Fig.8
CAUTION:
Always secure the sub-magazine in place, or the
•
staples can drop out and cause problems.
With the magazine loaded, if the tool is held
•
downward and the sub-magazine is opened, the
staples can fall out and present a danger to anyone
or anything below. Keep this in mind especially
when working in high locations.
OPERATION
Driving staples
Fig.9
Place the tool on the material to be fastened so that the
front and the rear of the tool contact the material flat. Do
not tip the tool to the right or left side. Hold the tool firmly
against the material. Then pull the trigger to drive the
staples.
If the staples are driven too shallow, press the tool head
as shown in the figure and drive the staples. If the staples
are still driven too shallow, adjust the driving depth by
turning the nut clockwise. Refer to ''Depth adjustment''.
Fig.10
CAUTION:
Do not operate the tool without staples. It shortens
•
the service life of the tool.
If the tool becomes jammed, do as follows. First, remove
the battery cartridge. Open the sub-magazine and
remove the stuck staple using a screwdriver or the like.
Downloaded from
www.Manualslib.com
manuals search engine
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY,
•
repairs, any other maintenance or adjustment
should be performed by Makita Authorized Service
Centers, always using Makita replacement parts.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Staples (5,000 pcs/case)
•
Various type of Makita genuine batteries and
•
chargers
6
or
attachments
are
Only use
accessory or