AFRISO EURO-INDEX DA 10 Betriebsanleitung Seite 48

5 Mounting
MECHANICAL LOADS AND STRESS
• Verify that the product is not subjected to mechanical loads and stress.
• Verify that a minimum horizontal distance of 20 mm is maintained when you
mount several products.
• Verify that a minimum vertical distance of 10 mm is maintained when you
mount several products.
Failure to follow these instructions can result in equipment damage.
INCORRECT HANDLING
• Verify that the product is not installed in the vicinity of sources of electrical
interference.
• Verify compliance with the permissible ambient conditions.
Failure to follow these instructions can result in incorrect measurement
results.
5.1 Preparing mounting
1. Saw a cutout of 94 x 46 mm in the control panel.
5.2 Mounting the product
1. Slide the seal over the product from behind.
2. Slide the product into the panel.
3. Slide the retaining clips over the guide.
4. Snap the retaining clips into place.
Mounting
NOTICE
NOTICE
DA 10/12/14
EN
13