Check Tamper Oil; Check Fuel Level - Zipper Maschinen ZI-RAM80C Betriebsanleitung

Check tamper oil

Oil capacity: 0,8 litre
Oil type: SF 15W-40
 To check the engine oil level, place the rammer after 10 minutes with the engine off on secure,
level ground
 Clean pollution in the area of the sight glass (F).
 Check the oil level on sight glass (F). The oil level is OK if the sight glass is full or ¾ full.
If no oil is visible oil must be supplied.
 Tilt the tamper until the roll off bar (I) is on the ground.
 Loosen the oil screw (F).
 Fill in oil
 Thigten the oil screw
 Place tamper in upright position

Check fuel level

Fuel capacity: 2,7 litre
Fuel type: ROZ 95
 The ZI-RAM80C is being powered with petrol (min. octane 95)
 Pay attention to all security regulations in connection with fuel.
 Remove fuel tank cap, check fuel level by sight.
 If refueling is necessary, pay attention to all security regulations regarding refueling, refuel only
with filter.
 Refueling only with filter.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RAM80C
SETUP
27