Checks And Tasks Before First Operation; Check Motor Oil - Zipper Maschinen ZI-RAM80C Betriebsanleitung

12 SETUP
Check the compactor plate, the air inlet, the muffler and the air filter condition.
Clean them if necessary with a mild solvent.
Do not use paint thinners, petrol or other aggressive chemicals or abrasives for cleaning – they
damage the machine.

Checks and tasks before first operation

Read, understand, and follow security and setup information
Check all fixing nuts and screws of the machine if tightened well! Not entirely tightened nuts and
screws might become even looser and be lost due to the vibration during operation
A too low oil level leads to engine damages.
Please understand that we do not accept any reclamations on engine damage being
caused by insufficient oil level.
The handling costs of claimed guarantee of defect engines that during service check turn
out to be caused by an insufficient oil level will be charged to the customer entirely.

Check motor oil!

Oil capacity: 0,6 litre
Oil type: SF 15W-40
 To check the engine oil level, place the rammer after 10 minutes with the engine off on secure,
level ground.
 The filter cap / dipstick from the oil filler neck (4) Remove and wipe clean.
 Insert the dipstick into the oil tank, but without tighten the screw and then remove it again. Check
the oil level on the dipstick.
 If the oil lever is to low top up the oil SF 15W40 to the edge of the oil filler neck.
ZIPPER MASCHINEN GmbH
ZI-RAM80C
N O T I C E
www.Zipper-Maschinen.at
ATTENTION!
SETUP
26