How To Pair Ipc; Ipc Pairing Status - Overmax Camspot NVR 4.0 Benutzerhandbuch

Setting 2: Wireless channel. Set Wi-Fi channel of the device to assure compliance
with local regulations and rules (fig. 17).
Setting 3: General settings. You can set system time, date format, time zone,
EN
or select language, resolution, automatic logging-out, battery saving, camera
synchronization and system configuration assistant. The interface will look
as presented below in the figure. Press [Save] when settings modification is
finished (fig. 18).
Setting 4: Network settings. You can make the program automatically download
IP address or you can set it manually and diagnose network. The interface will
look as presented below in the figure. When the operation is finished, press
[Save] on system configuration assistant (fig. 19).
Setting 5: Hard drive settings. Here you can find a list of currently available hard
drives, with regard to model, capacity, disk status and formatting variants. After
loading, the specific hard drive may be formatted, the disc status will turn into
„formatted". The interface will look as presented below in the figure. When the
operation is finished, press [OK] to confirm settings above. If you press [Cancel],
all changes will not be saved (fig. 20).

4.3 How to pair IPC

4.3.1 IPC pairing status

Description of function: Used to check IPC channel status and its connection.
Steps: Click the main interface with a right key of the mouse and select [Pair
IPC]. You will see an additional menu. Press it with a right key of the mouse and
select IPC pairing interface. Check IPC channel status. Like in the figure below,
you can check channel status (fig. 21).
4.3.2 Wireless network status
Description of function: Used to check network status of all IPC and NVR in
IPC channel.