Weidmuller HPG 60 Betriebs- Und Wartungsanleitung Seite 27

In order to implement or remove the dies push the unlocking knob (1 und 2)
2
and hold it down (see Figure 2).
Figure 2 Crimping head with dies
Put the two halves of the dies one after the other in the collet of the crimp
3
head.
Push the dies carefully from the side into the collet until the bullet slips in
4
the track of the dies. Make sure, that the dies have snapped in correctly
before processing.
Close the shackle until the latch snaps in.
5
To remove the dies open push the unlocking knob push them carefully to
6
the side.
NOTICE
The latch has to be snapped in completely before starting to
crimp. Otherwise the bolting device will be damaged and safe
processing is not guaranteed any longer.
2635530000/00/10.2018
1
Operating
2
27