Operation; Preparatory Activities; Greasing The Ram Surface; Bleeding The Hydraulic System - Zipper Maschinen ZI-HS12TN Betriebsanleitung

16

OPERATION

16.1

Preparatory activities

16.1.1 Greasing the ram surface

Apply a thin layer of grease to the surface of the ram of your log splitter before starting work.
This will prolong the life of the tool.

16.1.2 Bleeding the hydraulic system

Never forget to loosen the oil tank cap! Otherwise the air in the system will be
compressed and released again and again, which will destroy the seals of the
hydraulic circuit and make the log splitter unusable.
16.1.3 Checking the rotation direction of the motor –
for models ZI-HS12TN and ZI-HS14TN only
Never run the motor in the wrong rotation direction. This will damage the pump and
void the warranty.
If the splitting arm does not start moving after starting the motor, switch off the motor
immediately (position: O
inverter inside the plug - see picture on the left).
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HS10TN / ZI-HS12TN / ZI-HS14TN
N O T I C E
Vent the hydraulic system before starting the log splitter.
To do this, loosen the cover of the hydraulic oil tank by a
few turns until the air can flow in and out gently.
The air flow through the oil tank should be visible during
operation.
To prevent oil from leaking out, the oil tank cover must
be tightly closed before each transport!
N O T I C E
Phase inverter
Check the rotation direction of the motor. Switch on the
motor (position: O
automatically moves to the highest position.
If the splitting arm is already in the highest position,
activate the splitting mechanism by moving the two
control levers downwards and the splitting arm will move
downwards.
). Then reverse the polarity of the motor using a screwdriver (phase
FF
). After switching on, the splitting arm
N
OPERATION
31