Starting The Engine; Shutting Off The Engine; Using The Motion-Control Levers - Toro TimeCutter ZS 4200S Bedienungsanleitung

Starting the Engine

Important:
Do not engage the starter for more
than 5 seconds at a time. Engaging the starter
motor for more than 5 seconds can damage the
starter motor. If the engine fails to start, wait 10
seconds before operating the engine starter again.
Note:
It may be necessary to hold the lever against
the stop, in the choke position, while trying to start the
engine (Figure 22).
Figure 22

Shutting Off the Engine

1. Disengage the blades by moving the
blade-control switch to the O
22).
2. Move the motion-control levers outward to the
P position.
ARK
3. Move the throttle control to the F
4. Turn the key to the O
the key.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the key and engage the
parking brake when leaving the machine
unattended.
Using the Motion-Control
Levers
g296102
1. Motion-control
lever—P
ARK
2. Center, unlocked position
3. Forward
19
position
FF
position and remove
FF
Figure 23
4. Backward
position
5. Front of machine
(Figure
position.
AST
g004532