Contracor CAB-110P Bedienungsanleitung Seite 13

Overilling will result in media carryover to the dust collector and possibly blockage in the
conveying hose. Reill only after all media has been recovered from the cabinet.
Table 4.1 The minimum amount of media to charge the system is as follows
CAB-110P
20 kg
4.2.2 Unloading Media
To empty media out of the blast cabinet, pressure must irst be reduced to 3bar. Then
place an empty container on the grate of the cabinet. Remove nozzle and washer from
nozzle holder, close the door and choke valve, and depress the foot pedal.
Media low is to be directed into the container until full. Repeat as often as necessary
until the machine is empty. Whilst handling the container, local Operational Health and
Safety regulations are to be observed. When the machine is empty, return the choke valve
to the fully open position. Inspect and clean the threads on nozzle holder and nozzle before
reinstalling nozzle washer and nozzle.
4.2.3 Parts loading and unloading
Parts may be loaded and unloaded through either door. Blasted parts must be free of
oil, water, grease, or other contaminants that will clog media or ilters. By closing the door,
be certain that the door is sealed securely or door interlock system will prevent blasting.
4.2.4 Blasting operation
ATTENTION!
Always close cabinet, reclaimer and dust collector doors before blasting.
Keep all doors closed during blasting.
Always wear blast gloves.
Avoid pointing the blast nozzle toward the view window.
Use the blow-off nozzle to blow media off parts before opening doors.
After blasting, keep doors closed and exhauster on until the cabinet is
clear of all airborne dust.
Stop blasting immediately if dust leaks are detected.
CAB-110P/CAB-135P Art. 15205/15206
CONTRACOR ®
CAB-135P
40 kg
13