Assembly - AL-KO GTLi 18V Betriebsanleitung

en
If working on slopes:
Never work on a smooth and slippery
slope.
Always make sure you are positioned se-
curely.
Always work across the slope, never up-
ward or downward.
Do not work on slopes with a more than
10° gradient!
Take particular care when turning!
After contact with a foreign object:
Switch off the engine.
Examine the device for damage.
The machine must not be operated if the ope-
rator is under the influence of alcohol, drugs
or medication.
Comply with the accident prevention regula-
tions.
Do not get the appliance wet or expose it to
moisture.
Keep children away from appliances equip-
ped with batteries.
Safety notes for battery and charger
CAUTION!
Caution - Risk of fire and explosion!
Do not open the appliance. Danger
of short circuit.
Do not put the appliance onto an
open fire.
Protect the appliance against heat
and direct sunlight.
Only recharge batteries in chargers that are
recommended by the manufacturer. Using a
charger intended for one particular type of
battery with a different type of battery repres-
ents a fire risk.
Only use batteries in the electrical imple-
ments that are intended for this purpose.
Using other batteries can lead to injuries and
represents the risk of fire.
Keep the unused battery away from paper
clips, coins, keys, nails, screws or other small
metal objects that could short-circuit the con-
tacts. A short circuit between the battery con-
tacts can result in burns or fire.
16
Incorrect use can result in fluid leaking out
of the battery. Avoid contact with the fluid. In
case of inadvertent contact, rinse off with wa-
ter. If the fluid gets into your eye, seek additio-
nal medical assistance. Leaking battery fluid
can lead to skin irritations or burns.
Each time before using the charger, check
the housing, plug and cable for damage.
Do not use the charger if it is damaged.
Do not open the charger! Renew the charger
if it is defective.
Protect the appliance, battery and charger
against moisture. Only charge indoors.
Only have electrical appliances repaired by
qualified electricians, and only using genuine
spare parts. This ensures that the appliance
remains safe.

ASSEMBLY

CAUTION!
The machine must not be put in opera-
tion before it has been assembled com-
pletely.
CAUTION!
Do not insert the battery until the appli-
ance has been completely assembled.
Install the guard plate
The knife integrated in the guard plate
automatically cuts the line to the opti-
mum length.
1. Set the guard plate in relation to the cutter
head (2-1).
2. Make sure that the line is exposed.
3. Screw the guard plate on at the rear with the
supplied screws (2-1).
4. Place the guide wheel on the guard hood and
tighten the screws (2.2).
Installation of auxiliary handle
The holder of the auxiliary handle is mounted on
the telescopic handle. The supplied replacement
spool is integrated in the holder.
Installation of auxiliary handle
The angle of the handle can be individually adjus-
ted using the tip lever.
1. Push the holder onto the shaft.
2. Pull the grip bar of the auxiliary handle slightly
apart (3-1).
Safety instructions
GTLi 18V