Safety Instructions - mamibot EXVAC890 GLORY Gebrauchsanweisung

Safety Instructions

Please read all instructions carefully, and keep it at hand for setting up,
using and maintaining GLORY. Any operation that against the following
instructions may damage GLORY or cause injury.
Notes for Main Unit and Components
Warning
01.Do not disassemble,repair or refit GLORY without authorization;
otherwise it may damage GLORY or pose a hazard.
02.Do not use the product in an environment with risk of fire or explosion.
03.Only the original power adapter can be used for GLORY; otherwise
GLORY may be damaged or catch on fire.
04.Do not stand or sit on GLORY; doing so could damage GLORY or
cause it to fall over.
05.When the metal part of the power plug is dusty, please wipe it with
a dry cloth.
06.The power adapter is applied to a 100-240V AC voltage. Please plug
into the socket properly and keep away from children.
07.Do not wash or soak the main body and electronic accessories in
water; otherwise GLORY may be damaged by a short circuit.
08.Do not damage, load weight on, heat, pull, or bend GLORY.
09.During cleaning, please pay attention to the safety of toddlers and
elders at home to avoid injury(Please pay special attention to toddlers).
10.This product is for home use. Please do not use it outdoors.
11.Do not allow metal and conductive materials to contact the batt-
ery; doing so may cause a short circuit.
12.Do not allow to be used as toy. Close attention is necessary when
used by or near children.
Attentions
01.Do not touch GLORY with wet hands; doing so may cause an electric
shock.
02.Please do not place GLORY in places where it could easily fall,
such as tables, chairs, high platforms in room, etc.
03.The product has a sophisticated design and should be protected
from long-term exposure to sunlight.
04.Please do not use GLORY in humid environments, such as bath-rooms.
05.Please do not place GLORY near cigarette butts, lighters or other
open fires.
06.Please clean GLORY after charging finished.
07.Please turn off the power switch on the side of GLORY when GLORY
is out of service for a long time.
08. Please check carefully to see if the power adapter is connected to
the socket prior to use, to avoid damage to the robot.
2