Glory Working Mode - mamibot EXVAC890 GLORY Gebrauchsanweisung

GLORY Working Mode

Auto Cleaning
The Laser of GLORY will explore one part of the room first, then start to
clean the detected room in "Zigzag" path. After the detected area
cleaning is finished, GLORY will explore other new areas for next plan
until the whole room cleaning is completed. GLORY works in Auto
cleaning mode when press the Start/Stop button on GLORY, or the Auto
cleaning button on the remote control, or the Start button on the App.
Turbo Mode
Press the button in the Auto Cleaning mode to enter the Turbo
mode. Users can also adjust the suction power via APP, there are
FOUR levels including: Silence, Standard, Strong suction and MAX.
Mopping Mode
To enter the Mopping mode with water tank attached to the robot,
GLORY will work as the path in Auto Cleaning mode. There are three
levels of water dripping speed: low,medium and high.
Not-to-go Area Setting
To set the area which users'do not want GLORY to enter by the APP,
it is similar to the function of a virtual wall.
Spot Cleaning
Press this button to enter Spot cleaning mode.
Position
Press the Position button on the APP, GLORY will say "I am here", it would
be useful for finding GLORY if it is stuck.
Notice:
The main power switch of GLORY should be kept on.
The remaining battery of GLORY is more than 5%.
The voice of GLORY is switched on.
14