mamibot EXVAC890 GLORY Gebrauchsanweisung Seite 26

Wi-Fi Setup Requirements
Before Wi-Fi setup, please make sure that GLORY and your Wi-Fi network
meet the following requirements.
1. The Wi-Fi Network you are using is 2.4GHz router or a dual-band router.
GLORY does not support 5GHz frequency band.
2. The Wi-Fi network you are using supports 802.11b/g/n and IPv4 protocol.
3. Please make sure that there is no illegal character in your SSID, or the
Wi-Fi may not be recognized.
4. Please don't use a virtual Private Network(VPN) for connection.
5. Please make sure that your password is correct when entering.
6. Please make sure GLORY is fully charged or on the dock station, and the
main power switch on the side of GLORY is turned on.
7. Please make sure that you hear the voice of prompt for connection,
and the Wi-Fi status light flashes white slowly.
8. Please make sure that your GLORY, Router and Smartphone are as close
as possible.
APP Connecting
1. App downloading
Scan the below QR code(Fig.2) of Weback app(Fig.1), or down load the
Weback app from the App Store(IOS devices) or Google Play(Android
devices).
weback
2. Log in/Register weback ID.
Enter the app, log in with your weback ID directly, or follow the instructions
and creat a new user ID, then log in and enter weback interface.
3. Connect the GLORY to the App.
Tap the " Tap the " " icon and enter the interface as Fig.8 to add GLORY to your " icon and enter the interface as Fig.8 to add GLORY to your
weback ID: Scan the following QR code (Fig.9) of GLORY or from bottom
shell of GLORY or manual input the number of "exvac-890-"(Fig.10) to
enter the interface as(Fig.11). Choosing your WIFI and enter password of
the WIFI, then confirm as Fig.12. and Fig.13.
Fig.1
21
Fig.2
IOS Google Play