Safety Instructions - mamibot EXVAC880 Wisor Gebrauchsanleitung

Safety Instructions

Please read all instructions carefully, and keep it at hand for setting up,
using and maintaining Wisor. Any operation that against the following
instructions may damage Wisor or cause injury.
Notes for Main Unit and Components
Warning
01. Do not disassemble,repair or refit Wisor without authorization;
otherwise it may damage Wisor or pose a hazard.
02. Do not use the product in an environment with risk of fire or explosion.
03. Only the original power adapter can be used for Wisor; otherwise
Wisor may be damaged or catch on fire.
04. Do not stand or sit on Wisor; doing so could damage Wisor or
cause it to fall over.
05. When the metal part of the power plug is dusty, please wipe it with
a dry cloth.
06. The power adapter is applied to a 100 - 240V AC voltage. Please
plug into the socket properly and keep away from children.
07. Do not wash or soak the main body and electronic accessories in
water; otherwise Wisor may be damaged by a short circuit.
08. Do not damage, load weight on, heat, pull, or bend Wisor.
09. During cleaning, please pay attention to the safety of toddlers and
elders at home to avoid injury(Please pay special attention to toddlers).
10. This product is for home use. Please do not use it outdoors.
11. Do not allow metal and conductive materials to contact the battery;
doing so may cause a short circuit.
12. Do not allow to be used a toy. Close attention is necessary when
used by or near children.
Attentions
01. Do not touch Wisor with wet hands; doing so may cause an electric
shock.
02. Please do not place Wisor in places where it could easily fall,
such as tables, chairs, high platforms in room, etc.
03. The product has a sophisticated design and should be protected
from long-term exposure to sunlight.
04. Please do not use Wisor in humid environments, such as bath-rooms.
05. Please do not place Wisor near cigarette butts, lighters or other
open fires.
06. Please clean Wisor after charging finished.
07. Please turn off the power switch on the side of Wisor when Wisor
is out of service for a long time.
08. Please check carefully to see if the power adapter is connected to
the socket prior to use, to avoid damage to the robot.
2