NEC MultiSync P750 Handbuch Seite 7

E - 2
A high contrast screen with a .25 mm mask pitch sharpens image clarity
and enhances detail. On-screen information is easier to read.
The flat square CRT technology reduces image distortion and glare.
Plug and Play
Plug and Play is the new Microsoft
provide automatic peripheral connections without confusing and
time-consuming setup. When used with a Plug and Play compatible system
and video card, the MultiSync P750 monitor automatically tells the system
its identification and capabilities. The system will then select its highest
resolution and refresh rate to take advantage of your MultiSync monitor.
D-SUB/BNC Selection
Up-front BNC/D-SUB Selection Button on the monitors allows you to
connect two systems to one MultiSync P750 monitor. This front panel
button allows you to select a system. Use the MultiCable with the
D-Sub connector to display the video of one system, and use the BNC
inputs to display the video of another system. Using the same P750
monitor, you can easily select either one of the systems by simply
pushing the BNC/D-SUB Button.
ErgoDesign
The MultiSync ErgoDesign features enhance human ergonomics
(human and earth conditions). MultiSync monitor's ErgoDesign will
improve the working environment, protect the health of the user and
save money. ErgoDesign parallels the strict European standards of
power management and reduced emissions:
–
automatic display power-down (also known as NUTEK
specification 803299)
–
emission characteristics (stricter than those referred to as
reduced electromagnetic fields as recommended by MPR II
and, for JC-1744UMB, also by TCO)
–
safety (EN 60950)
®
solution with Windows
Introduction
®
95 to