Connection Diagram - Axis P1355-E Installationsanleitung

Page 16
Note:
The I/O connector on the network camera is connected to the housing electronics at deliv-
ery and will trigger an input port event to indicate a fan or heater error when activated.
Please refer to the User Manual, available on www.axis.com, for information on how to set
up an event.
Function
GND
3.3 V DC
Power
Digital
Input
Digital
Output

Connection diagram

The following connection diagram gives an example of how to connect an auxiliary device to the
network camera.
Downloaded from www.Manualslib.com
Pin Notes
1 Ground
2 Can be used to power auxiliary equipment.
Note: This pin can only be used as power out.
3 Connect to GND to activate, or leave floating
(unconnected) to deactivate.
Note: Connected to housing electronics at delivery.
4 Uses an open-drain NFET transistor with the source
connected to GND. If used with an external relay, a
diode must be connected in parallel with the load,
for protection against voltage transients.
3.3V
max. 50mA
G
manuals search engine
AXIS P1355-E/P1357-E Installation Guide
1
2
3
4
D
S
Specifications
Max load = 50 mA
Min. input = -40 V DC
Max. input= +40 V DC
Max. load =100 mA
Max. voltage = + 40 V DC