Axis P1355-E Installationsanleitung Seite 12

Page 12
Access the Video Stream
Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup
Adjust zoom and focus
To adjust the zoom and focus follow these instructions:
1. Open the product's home page and go to Setup > Basic Setup > Focus.
2. On the Basic tab, click Open iris. If the button is inactive, the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Loosen the zoom and focus pullers on the lens by turning them anti-clockwise. Move the pullers
to set zoom and focus and check the quality of the image in the image window.
Note:
5. Retighten the zoom and focus pullers.
6. On the Focus page, click Fine-tune focus automatically and wait until the automatic fine-
tuning is completed.
7. Click Enable iris. If the button is inactive, the iris has already been enabled.
8. If needed, make further adjustments on the Advanced tab. See the online help or User Manual
for more information.
Notes:
• Set focus as precisely as possible with the focus puller or Focus Assistant before starting the
automatic fine-tuning. Using the focus puller normally gives the best result.
Downloaded from www.Manualslib.com
If the camera is mounted so that one cannot look at the image and move the
pullers at the same time, use the Focus Assistant instead. See page 13.
manuals search engine
AXIS P1355-E/P1357-E Installation Guide