Optional Accessories; Protecting The Environment - DeWalt DWP849X Bersetzt Von Den Originalanweisungen

• The effect of electronic speed control is much easier to
observe at lower speed settings (2600 RPM and below), than
at high speeds.
A conventional polisher running at a typical no-load speed of
2400 RPM slows down to about 2000 RPM under a polishing
load. Your DWP849X will continue to run at 2400 RPM (or any
speed you select with the control wheel) as a load is applied.
If the speed is too great, slow the tool down with either the
trigger switch or the control wheel.
Polishing (Fig. D)
1. Without turning the tool on, grasp the handles of the tool
and pick it up.
2. Keep the tool away from your body and depress the
trigger switch.
3. Make sure you have a firm grip on the handles.
4. Move the tool evenly over the surface of the workpiece,
without applying pressure.
5. Switch off the machine before taking the tool from
the surface.
6. Check your work at short intervals.
The side handle 5 or the bale handle
changed to either side of the tool for left-handed or right-
handed operation.
Use utmost care when power polishing around or over sharp
objects and contours. It is very important to use the correct
pressure while polishing various sections of an automobile body.
For example, light pressure should be applied when polishing
over sharp edges of body panels, or over edges of the rain gutter
along the top.

WARNING: High-speed rubbing action of the polishing
bonnet upon the workpiece surface can build a static
charge on the metal portions of this tool resulting in a
static shock when touched.
MAINTENANCE
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from
power source before making any adjustments or
removing/installing attachments or accessories.
Before reconnecting the tool, depress and release the
trigger switch to ensure that the tool is off.
Lubrication
Your power tool requires no additional lubrication.
7 can be easily
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Motor Brushes (Fig. A)
Carbon brushes should be regularly inspected for wear.
• Be sure tool is unplugged.
• Unscrew the plastic brush inspection caps
sides of the motor housing) and withdraw the spring and
brush assemblies from the tool.
• Keep brushes clean and sliding freely in their guides.
• When the brushes are worn down to the line closest to the
spring, they must be replaced.

Optional Accessories


WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
EngLIsh
3 (located in the
WALT recommended
e
25