Maintenance Instructions - Makita UV3600 Original Bedienungsanleitung

• Do not run. Only walk during
operation.
• Pay particular attention to your
footings when working on a
slope.
• Do not work straight up or down
on a slope. Always work along
horizontal line.
• Be
turning the machine on a slope.
• Never work on a steep slope.
• Pay extreme attention when
reversing or pulling the machine
towards you.
• Do not overreach. Keep proper
footing and balance at all times.
This enables better control of
the machine in unexpected
situations.
• Always remember:
– Keep your feet away from
the cutting tools.
– Do not tilt the machine.
– Do not stand in front of the
discharge opening.
– Never let your hands or other
part of the body or clothing
place near moving parts.
• Do not force the machine. It does
the job better and safer at the
rate for which it was designed.
Frequent overload may cause
motor damage or fire.
• Switch
unplug:
– Whenever
machine unattended
– Before clearing a blockage
or any fault
– Before checking, cleaning or
working on the machine
Downloaded from www.Manualslib.com
especially careful
off the motor
leaving
manuals search engine
– Before
adjustments,
accessories or storing
– When the machine hits a
foreign object. Wait until the
machine cools down. Inspect
the machine and replace
the parts if needed before
when continuing operation
– Whenever
starts vibrating or making
noise unusually
– When attaching or removing
grass catcher
– When someone enters your
working area
– When crossing surface other
than grass
– When transporting.
• Stop the cutting tool:
– If you have to tilt the
machine
– When
other than grass
– Transporting the machine
to and from surfaces to be
worked.
• Pay attention to the cutting tools.
They do not stop immediately
after switch off.

Maintenance instructions

• Have your machine serviced by
our authorized service center,
and
always
replacement
the
repair and poor maintenance
can shorten the life of the
machine and increase the risk of
accidents.
making
changing
the machine
crossing surfaces
using only genuine
parts. Incorrect
any
9