Werbung
ENGLISH
60
Help Message Displayed
INSERT WATER SPOUT
INSERT
CAPPUCCINATORE
INSERT
CAPPUCCINATORE
COVER
INSERT VALVE
INTO
CAPPUCCINATORE
RESTART TO SOLVE
Downloaded from
www.Manualslib.com
How to Reset the Message
Insert the hot water dispenser to start dispensing. Press ESC to exit.
ESC
Insert the Cappuccinatore to start pouring. Press ESC to exit.
ESC
Insert the Cappuccinatore cover to start brewing; see point (7) of sect.
"Daily Cleaning of the Cappuccinatore". Press "ESC" to exit.
ESC
Insert the valve in the Cappuccinatore to start brewing; see point (8) of
sect. "Daily Cleaning of the Cappuccinatore". Press "ESC" to exit.
ESC
The machine needs to be descaled. Follow the steps described in the
"Descaling" chapter of this manual.
Please note that not descaling your machine will ultimately make it stop
working properly. In this case repair is NOT covered under your warranty.
The machine needs the "INTENZA+" water fi lter to be replaced.
Red light fl ashes. Press the "
Take note of the code (E xx) shown in the display at the bottom.
Turn off the machine. After 30 seconds, turn it on again. Try this 2 or 3
times.
If the machine does not start, contact the Philips SAECO hotline in your
country and tell them the code shown in the display. You can fi nd its
contact details in the warranty booklet by-packed separately or on
www.philips.com/support.
manuals search engine
" button to exit the stand-by mode.
Werbung
Kapitel
