Troubleshooting - Spectral BRA2 Bedienungsanleitung

Troubleshooting

Here is an overview of the most common problems. If you have any further questions please contact your Spectral dealer.
Problem Possible cause
Sound system does 1. Power cable not connected to the power outlet and / or sound
not turn on. system.
Sound system does 1. The battery is flat.
not respond
2. Protective film is not removed.
to remote control.
No sound or volu- 1. Device does not output a signal. (Output on the source device is
me is too low. not activated or volume is set too low).
2. Cable is not correctly connected/defective cable.
The device does 1. The AUT function is initially disabled upon delivery (OFF).
not automatically
2. The device has been put in standby mode via the „"Power"" button.
switch on for the
optical and coaxial
input.
3. The device was switched to the other digital input which has no
signal and has turned off automatically.
58
Downloaded from www.Manualslib.com manuals search engine
Solution
Check connection.
1. Change the battery.
2. Remove the protective film on the remote control.
1. Unlock output and/or increase volume (please see the operating
instructions for the device).
2.1 Check the connection on the device to the sound system and
replace the cable if necessary.
2.2 Check that the protective cap has been removed from
the plug of the optical cable.
1. Activate the AUT function (ON), page50.
2. Turn on the device using the „"Power"" button on the remote
and wait until it automatically goes into standby mode.
3. Turn on the device using the „"Power"" button on the remote
and select the digital input to which the desired source device is
connected.