Automatic Selection Of The Bt Input (Sel) - Spectral BRA2 Bedienungsanleitung

Automatic selection of the BT input (SEL)

If this function is enabled (AUT), the sound system automatically switches to the BT input as soon as it detects an audio signal from the mobile device. If this function is disab-
led (MAN) the input must be selected manually. This function is disabled (MAN) as standard.
To enable/disable this function, follow these steps:
1 With the device powered on, press and hold the „Play Mode" button for more than 3 seconds until AUT appears in the display.
2 Press the „Play Mode" again briefly until SEL appears in the display.
3 Press the „Volume +" button to enable the function (AUT).
4 Press the „Volume -" button to disable the function (MAN).
5 Exit the menu by again pressing and holding the „Play Mode" button for more than 3 seconds. If no input is made within 10 seconds, the unit will automatically exit the
configuration menu.
Note: Depending on the mobile device used, the sound system can be switched to BT input also when typing a message or
other system sounds when automatic mode is enabled.
If the SEL function is enabled (AUT), the BT input can no longer be selected using the „Input" button.
If the SEL function is enabled (AUT), the sound system can be connected to the mobile device using the „Bluetooth® Pairing" button,
regardless of the selected input signal.
Downloaded from www.Manualslib.com manuals search engine
53